Skip to content
Om Engineering Services — Waterproofing & Building Painting SpecialistsOm EngineeringWaterproofing & Painting

Thermal Image Water Leakage Detection in Chennai

Most waterproofing fails because the contractor treated the stain, not the source. We run a thermal imaging survey first — an infrared camera reads surface temperature differences to reveal where moisture is actually travelling inside your slab or wall. You get a diagnosis report before anyone touches a chisel.

Specialization

  • Infrared Thermography Moisture Mapping
  • Concealed Pipeline Leak Tracing
  • Slab & Ceiling Seepage Source Identification
  • Terrace Ponding & Dead-slope Detection
  • Pre-purchase / Pre-handover Building Moisture Audit
  • Post-repair Verification Scan

Be it — Ceiling seepage, wall dampness, concealed pipe leak, terrace leakage or basement ingress.

Systems & methods

What we actually apply, and where each one fits

Specifying the wrong system is the most common reason waterproofing and paintwork fails early. Here is how we choose.

Infrared Thermographic Survey

A calibrated thermal camera scans ceilings, walls and terrace surfaces. Wet material holds and releases heat differently from dry material, so moisture shows up as a distinct thermal signature — even under plaster and paint.

Best for:
Locating the source of a ceiling or wall stain without demolition

Concealed Pipeline Leak Tracing

Hot and cold line leaks behind tiling and inside walls are traced by thermal gradient, then confirmed with moisture-meter readings so we break exactly one spot instead of five.

Best for:
Bathrooms, kitchens, shafts and buried supply lines

Diagnosis Report

You receive annotated thermal images, moisture readings, the identified root cause and the recommended treatment system with scope and cost. The report is yours whether or not you award us the work.

Best for:
Housing societies and facility managers who need documentation

Post-repair Verification Scan

After treatment and a wet test, we re-scan the same points and hand over a comparison set. This is what our warranty is written against.

Best for:
Proving the leak is actually closed

Our works

Photos from this type of work

Infrared thermal camera image showing a cold moisture plume across an apartment ceiling slab in Chennai
Thermal scan revealing concealed slab leak — Chennai apartment
Thermal imaging survey mapping damp patches on an interior wall in Avadi before repainting
Moisture mapping of damp wall before painting — Avadi
Thermal image tracing a concealed hot water pipeline leak behind bathroom wall tiles
Concealed pipeline leak traced behind bathroom tiling

Our associates

Dr. FixitSikaFosrocAsian PaintsBerger PaintsSTP LimitedMYK LaticreteNerolac

FAQ

Questions about this service

Do you need to break the wall to find the leak?

No. The thermal survey is completely non-destructive. We only open the one confirmed spot at the time of repair, which is usually far smaller than the exploratory damage a conventional approach causes.

How much does thermal leak detection cost in Chennai?

It is charged as a fixed inspection fee based on the built-up area surveyed, and it is adjusted against the repair cost if you award us the waterproofing work. Call us with your area and we will quote on the phone.

How long does a survey take?

A typical apartment or independent house takes two to three hours. A factory or commercial block is scoped on site.

Can thermal imaging see through walls?

It reads surface temperature, not through-wall images. Moisture inside the structure changes the surface temperature above it, which is what makes the leak path visible.

CallWhatsAppFree Quote
Call NowWhatsApp